All Figures

$\begin{figure} \par\includegraphics[height=8cm,width=7cm,clip]{0056fig1.eps} \end{figure}$ Figure 1: The effect of irradiation on the specific intensity distribution for models with log g = 3.5, $T_{\rm eff} = 5300$ K irradiated by a model with T^* = 11 568 K, log g^* = 4.0 as a function of the apparent radius r. Note that the if only six points are used (asterisks), limb-brightening is no longer detected. Filter b.
Open with DEXTER

In the text

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig2.eps} \end{figure}$ Figure 2: Monochromatic specific intensities for some irradiated models. The full lines represent the actual intensities while the asterisks denote the fitting obtained using the LSM-Eq. (2) prescription. The FCM calculations were carried out adopting the logarithmic approach (crosses). The irradiation parameters are indicated in the figure.
Open with DEXTER

In the text

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig3.eps} \end{figure}$ Figure 3: The relative difference $\Delta I\over {I}$ = $[I({\rm model}) - I({\rm fitting})] \over {I({\rm model})}$ near the border of the disk as a function of the logarithm of the wavelength. The dashed line denotes the results obtained using Eq. (2) and adopting the LSM. The continuous line represents the FCM results for the logarithmic specific intensity approximation.
Open with DEXTER

In the text

$\begin{figure} \par\includegraphics[height=13.3cm,width=11.8cm,clip]{0056fig4.eps} \end{figure}$ Figure 4: The specific intensity distribution for irradiated models in the case of filter b. The conditions of irradiation are indicated inside each frame. Continuous lines denote the actual intensities, while asterisks and crosses represent the Eq. (2)-LSM and FCM (logarithmic) matches, respectively.
Open with DEXTER

In the text

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig5.eps} \end{figure}$ Figure 5: The monochromatic F'/F test for irradiated models.
Open with DEXTER

In the text

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig6.eps} \end{figure}$ Figure 6: The passband F'/F test for some irradiated models.
Open with DEXTER

In the text

$\begin{figure} \par\includegraphics[height=8cm,width=7cm,clip]{0056fig1.eps} \end{figure}$	Figure 1: The effect of irradiation on the specific intensity distribution for models with log g = 3.5, $T_{\rm eff} = 5300$ K irradiated by a model with T^* = 11 568 K, log g^* = 4.0 as a function of the apparent radius r. Note that the if only six points are used (asterisks), limb-brightening is no longer detected. Filter b.
Open with DEXTER

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig2.eps} \end{figure}$	Figure 2: Monochromatic specific intensities for some irradiated models. The full lines represent the actual intensities while the asterisks denote the fitting obtained using the LSM-Eq. (2) prescription. The FCM calculations were carried out adopting the logarithmic approach (crosses). The irradiation parameters are indicated in the figure.
Open with DEXTER

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig3.eps} \end{figure}$	Figure 3: The relative difference $\Delta I\over {I}$ = $[I({\rm model}) - I({\rm fitting})] \over {I({\rm model})}$ near the border of the disk as a function of the logarithm of the wavelength. The dashed line denotes the results obtained using Eq. (2) and adopting the LSM. The continuous line represents the FCM results for the logarithmic specific intensity approximation.
Open with DEXTER

$\begin{figure} \par\includegraphics[height=13.3cm,width=11.8cm,clip]{0056fig4.eps} \end{figure}$	Figure 4: The specific intensity distribution for irradiated models in the case of filter b. The conditions of irradiation are indicated inside each frame. Continuous lines denote the actual intensities, while asterisks and crosses represent the Eq. (2)-LSM and FCM (logarithmic) matches, respectively.
Open with DEXTER

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig5.eps} \end{figure}$	Figure 5: The monochromatic F'/F test for irradiated models.
Open with DEXTER

$\begin{figure} \par\includegraphics[height=10cm,width=8.8cm,clip]{0056fig6.eps} \end{figure}$	Figure 6: The passband F'/F test for some irradiated models.
Open with DEXTER