![]() |
Figure 1: The left panel shows a pulse-stack of fifty successive pulses of PSR B0818-13. Two successive drift bands are vertically separated by P3 and horizontally by P2. The products of our analysis are shown for three pulsars. The top panel shows the integrated pulse profile (solid line), the longitude-resolved modulation index (solid line with error bars) and the longitude-resolved standard deviation (open circles). Below this panel the LRFS is shown with - on its horizontal axis - the pulse longitude in degrees, which is also the scale for the abscissa of the plot above. Below the LRFS the 2DFS is plotted and the power in the 2DFS is vertically integrated between the dashed lines, producing the bottom plots. Both the LRFS and 2DFS are horizontally integrated, producing the side-panels of the spectra. |
Open with DEXTER |
![]() |
Figure 2: The solid line shows the fraction of pulsars we observe to exhibit the drifting phenomenon versus the measured S/N ratio of the observation. The dashed histogram shows the total number of pulsars observed in each S/N ratio bin. The root-mean-square (rms) is calculated as an estimate for the error (if the bin contains more than one observation). The dotted line is a fit for the S/N dependence of the chance to detect drifting subpulses and the dash-dotted line is that of Paper I. |
Open with DEXTER |
![]() |
Figure 3:
The ![]() ![]() |
Open with DEXTER |
![]() |
Figure 4:
The left panel shows the histogram of the
characteristic ages of the analyzed pulsars with a S/N ![]() |
Open with DEXTER |
![]() |
Figure 5:
The modulation index distribution of the
pulsars without drifting subpulses (solid line), with drifting
subpulses (dashed line) and with coherent drifting subpulses (dotted
line). Only observations with a
![]() |
Open with DEXTER |
![]() |
Figure 6:
The modulation index measured at 21 cm versus
that measured at 92 cm. The points would lie on the dotted line when
the modulation index is frequency independent. Only observations with
a
![]() |
Open with DEXTER |
![]() |
Figure 7:
The modulation index for all analyzed
pulsars with a
![]() |
Open with DEXTER |
![]() |
Figure 8:
The probability functions ![]() ![]() ![]() |
Open with DEXTER |
![]() |
Figure 9:
The measured value of the vertical drift band
separation P3 compared at the two frequencies. Also the low-S/Nobservations are included. The diffuse (Dif and Dif![]() |
Open with DEXTER |
![]() |
Figure 10:
The measured values of the vertical drift band
separation P3 versus the pulsar age of all the pulsars showing the
drifting phenomenon. The coherent drifters are the filled circles, the
Dif drifters (with drift feature clearly separated from the alias
borders) are the open circles and the Dif![]() |
Open with DEXTER |
![]() |
Figure A.1: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.2: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.3: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.4: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.5: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.6: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.7: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.8: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.9: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.10: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.11: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.12: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.13: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.14: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.15: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.16: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS is the 2DFS plotted. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.17: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.18: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.19: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.20: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.21: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.22: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |
![]() |
Figure A.23: The integrated pulse profile (solid line) and the modulation index (solid points) are shown in the top plot, which is aligned with the LRFS. Below the LRFS are two 2DFSs plotted of different pulse longitude ranges. The integrated power of the spectra are shown the side- and bottom-panels of the spectra. See the main text and Fig. 1 for further details about the plots. The badly affected frequencies in the spectra are set to zero. |