EDP Sciences Journals List
Advanced Search
Free access article

Issue A&A
Volume 441, Number 1, October I 2005
Page(s) 159 - 170
Section Interstellar and circumstellar matter
DOI http://dx.doi.org/10.1051/0004-6361:20053097



A&A 441, 159-170 (2005)
DOI: 10.1051/0004-6361:20053097

A combined optical/infrared spectral diagnostic analysis of the HH1 jet

B. Nisini1, F. Bacciotti2, T. Giannini1, F. Massi2, J. Eislöffel3, L. Podio2, 4 and T. P. Ray5

1  INAF - Osservatorio Astronomico di Roma, via di Frascati 33, 00040 Monteporzio Catone, Italy
    e-mail: nisini@mporzio.astro.it
2  INAF - Osservatorio Astrofisico di Arcetri, Largo E. Fermi 5, 50125 Florence, Italy
3  Thüringer Landessternwarte Tautenburg, Sternwarte 5, 07778 Tautenburg, Germany
4  Dipartimento di Astronomia e Scienza dello Spazio, Universitá degli Studi di Firenze, Largo E. Fermi 2, 50125 Firenze, Italy
5  School of Cosmic Physics, Dublin Institute for Advanced Studies, 5 Merrion Square, Dublin 2, Ireland

(Received 21 March 2005 / Accepted 26 May 2005 )

Abstract
Complete flux-calibrated spectra covering the spectral range from 6000 Å to 2.5 $\mu$m have been obtained along the HH1 jet and analysed in order to explore the potential of a combined optical/near-IR diagnostic applied to jets from young stellar objects. The main physical parameters (visual extinction, electron temperature and density, ionization fraction and total density) have been derived along the jet using various diagnostic line ratios. This multi-line analysis shows, in each spatially unresolved knot, the presence of zones at different excitation conditions, as expected from the cooling layers behind a shock front. In particular, a density stratification in the jet is evident from ratios of various lines of different critical density. We measure electron densities in the range 6 $\times$ 102-3 $\times$ 103 cm-3 with the [ $\ion{S}{ii}$] optical doublet lines, 4 $\times$ 103-104 cm-3 with the near-IR [ $\ion{Fe}{ii}$] lines, and 105-106 cm-3 with optical [ $\ion{Fe}{ii}$] and CaII lines. The electron temperature also shows variations, with values between 8000-11 000 K derived from optical/near-IR [ $\ion{Fe}{ii}$] lines and 11 000-20 000 K from a combined diagnostic employing optical [ $\ion{O}{i}$] and [ $\ion{N}{ii}$] lines. Thus [ $\ion{Fe}{ii}$] lines originate in a cooling layer located at larger distances from the shock front than that generating the optical lines, where the compression is higher and the temperature is declining.

The derived parameters were used to measure the mass flux along the jet, adopting different procedures, the advantages and limitations of which are discussed. The [ $\ion{Fe}{ii}$] 1.64 $\mu$m line luminosity turns out to be more suitable to measure $\dot{M}_{{\rm jet}}$ than the optical lines, since it samples a fraction of the total mass flowing through a knot larger than the [ $\ion{O}{i}$] or [ $\ion{S}{ii}$] lines. $\dot{M}_{{\rm jet}}$ is high in the initial part of the flow (~2.2 $\times$ 10 $^{-7}~M_{\odot}$ yr-1) but decreases by about an order of magnitude further out. Conversely, the mass flux associated with the warm molecular material is low, $\dot{M}_{{\rm H2}}$ ~ 10 $^{-9}~M_{\odot}$ yr-1, and does not show appreciable variations along the jet. We suggest that part of the mass flux in the external regions is not revealed in optical and IR lines because it is associated with a colder atomic component, which may be traced by the far-IR [ $\ion{O}{i}$]63 $\mu$m line.

Finally, we find that the gas-phase abundance of refractory species, such as Fe, C, Ca, and Ni, is lower than the solar value, with the lowest values (between 10 and 30% of solar) derived in the inner and densest regions. This suggests a significant fraction of dust grains may still be present in the jet beam, imposing constraints on the efficiency of grain destruction by multiple low-velocity shock events.


Key words: stars: circumstellar matter -- infrared: ISM -- ISM: Herbig-Haro objects -- ISM: jets and outflows

SIMBAD Objects



© ESO 2005


What is OpenURL?

The OpenURL standard is a protocol for transmission of metadata describing the resource that you wish to access. An OpenURL link contains article metadata and directs it to the OpenURL server of your choice. The OpenURL server can provide access to the resource and also offer complementary services (specific search engine, export of references...). The OpenURL link can be generated by different means.
  • If your librarian has set up your subscription with an OpenURL resolver, OpenURL links appear automatically on the abstract pages.
  • You can define your own OpenURL resolver with your EDPS Account. In this case your choice will be given priority over that of your library.
  • You can use an add-on for your browser (Firefox or I.E.) to display OpenURL links on a page (see http://www.openly.com/openurlref/). You should disable this module if you wish to use the OpenURL server that you or your library have defined.